 |
 |
 |
|
Fast Cap My Grip Black... the perfect Grip
My Grip customizes the impression of your hand on any tool. It also
increases shock absorption and dramatically reduces wrist and hand
fatigue. The material can be heated up in 200º water for 1 minute until
pliable, patted dry and then molded around any tool with the grip of your
hand. It can be cut off and remolded over and over again. |
|
|
|
|
|
 |
|
 |
|
Features
Fast Cap My Grip Black Great For
- Power tools
- Impact guns
- Jack hammers
- DA sanders
- Mauls
- Rakes
- Hockey sticks
- Golf clubs
- Canes
- Anything!
Instructions
- Submerge fully in 200° water for 1 minute.
- Remove from water and pat dry back side
- Wrap around handle, overlapping to create a solid seam.
- Grip and squeeze tightly for 30 to 60 seconds, then slowly remove hand from material leaving a full and deep impression.
- Mold top and bottom with other hand for appearance and a tight seal, while material is still warm.
- Allow material to cure at room temperature. Trim if needed.
|
|
|
 |
|
 |
|
